Anti-Slip Grit Tape Heavy-duty- (50 ft)

Heavy-duty anti-slip grit tape (also commonly referred to as traction tape or non-skid tread tape). It is a specialized safety product coated with a rough, mineral abrasive grain (similar to sandpaper) on one side and a strong, pressure-sensitive adhesive on the other. Common Applications: - This tape is primarily used to provide high traction and prevent slips, trips, and falls in both residential and commercial spaces. Typical locations include: • Stairs and steps (indoor and outdoor) • Ramps and walkways • Ladders and scaffolding platforms • Boats, docks, and marine decks • RV steps and running boards Installation Guide & Drying Times: - To ensure the tape adheres securely and lasts for years, it is critical to follow proper installation guidelines. Cutting corners on prep work will cause the edges to lift over time. 1. Prep the Surface: Clean the target surface thoroughly to remove all dirt, oil, grease, and debris. Use a degreaser or rubbing alcohol. The surface must be completely dry before moving to the next step. 2. Cut and Round Edges: Measure and cut the tape to your desired length. Pro Tip: Use heavy-duty scissors to round the corners of each strip. Rounded edges are significantly less likely to catch and peel up compared to sharp 90-degree corners. 3. Apply with Pressure: Peel off the protective backing paper slowly, positioning the tape smoothly onto the surface from one end to the other to avoid trapping air bubbles. Use a rubber hand roller (or press firmly with your hand or a wooden block) to ensure maximum adhesive contact. 4. Curing & Drying Time: While the tape bonds instantly, it requires time to set completely. Allow a full 24-hour buffer period before subjecting the tape to heavy foot traffic or moisture (such as rain or washing). Size of roll: - Roll has an approximate length of 15 to 18.3 meters (50 to 60 feet).