Hot Surface Ignitor (HSI) – Goodman / Amana Furnace Igniter

Hot Surface Ignitor (HSI) – Goodman / Amana Furnace Igniter | 120V | Flat Blade Style | Tested Condition: Used – Clean & Fully Functional (Tested) Availability: Ready for pickup / fast response Key Specifications: Type: Hot Surface Ignitor (HSI) Style: Flat Blade Ignitor Operating Voltage: 120V AC Element Material: Silicon Nitride / Flat Silicon Carbide Element Design: Flat Rectangular Blade Base Material: High-Temperature Ceramic Connector Type: 2-Pin White Plastic Locking Plug Mounting: Single-Screw Metal Bracket with Alignment Tab Ignition Temperature: Approximately 1,800°F – 2,500°F Compatibility: Goodman Gas Furnaces Amana Gas Furnaces Daikin Gas Furnaces Some Lennox Systems Some York Systems Common OEM Reference: B1401018S (verify with furnace model before purchase) Always verify connector style, bracket configuration, and ignitor dimensions before ordering. Function: The Hot Surface Ignitor (HSI) is responsible for lighting the gas burners during the heating cycle. Thermostat calls for heat. Furnace control board energizes the ignitor. Ignitor heats to a white-hot temperature. Gas valve opens. Gas ignites from the glowing ignitor. Flame sensor confirms ignition. Ignitor powers off until the next heating cycle. Applications: Residential Gas Furnaces Unit Heaters Boilers Gas-Fired Heating Equipment Why Buy This One? ✔ OEM-style flat blade design ✔ Faster and more reliable ignition than standing pilot systems ✔ Common Goodman / Amana replacement ✔ Tested & ready for installation ✔ Affordable furnace repair solution ⚠️ Important Handling Notice: Do not touch the ignitor element with bare fingers. Handle only by the ceramic base or metal bracket. Oils from skin can create hot spots and cause premature failure. Pickup: Toronto / GTA